Simons Voss Technologies Palm LDB Version 1.40 Service Manual download pdf (Page 6)

SMART RELAY SREL, SREL.ZK, SREL.ADV

Warning

! Do not use switching power supplies near Smart Relays. All mains adaptors

are to be provided by the customer; they cannot be acquired from SimonsVoss.

3.4 YOU NEED TO DETERMINE THE INSTALLATION LOCATION

The transponder transmission range for Smart Relay (read range) is a max. of 1.5 m,

but may be reduced in metallic environments, particularly in magnetic fields or where

there is aluminium.

Ideally, you should perform a read range test with an authorised transponder and a

battery-operated Smart Relay.

3.5 FURTHER INFORMATION

- All cabling used to connect Smart Relay should be type IY(ST)Y ....x0.6 -

twisted pair, shielded cable - and cables should not exceed 100 m in length.

Power losses should be taken into account when dimensioning the power

supply.

- The technical data regarding inputs and outputs are to be taken into account

(see Technical Data).

- All cabling must be installed and connected as per VDE regulations (VDE =

German Association of Electro-technology, Electronics & Information Technol-

ogy).

4.0 Before installation

 Unpack Smart Relay and check for any damage.

 Connect Smart Relay to a power supply or a battery.

 If Smart Relay is to be operated via a mains adapter, insert the backup battery

in the designated holder (see Installation of backup battery).

 Check that Smart Relay functions with a transponder in its as-delivered condi-

tion.

 Remove the housing if you install in a flush-fitted masonry box.

 If mounted on the surface, the base plate can be used as a template for the

drill holes (6 mm).

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

No comments

Simons Voss Technologies Palm LDB Version 1.40 Service Manual Page 6